Documentation / devicetree / bindings / sound / infineon,peb2466.yaml


Based on kernel version 6.9. Page generated on 2024-05-14 10:02 EST.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91
# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/sound/infineon,peb2466.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: Infineon PEB2466 codec

maintainers:
  - Herve Codina <herve.codina@bootlin.com>

description: |
  The Infineon PEB2466 codec is a programmable DSP-based four channels codec
  with filters capabilities.
 
  The time-slots used by the codec must be set and so, the properties
  'dai-tdm-slot-num', 'dai-tdm-slot-width', 'dai-tdm-slot-tx-mask' and
  'dai-tdm-slot-rx-mask' must be present in the sound card node for sub-nodes
  that involve the codec. The codec uses one 8bit time-slot per channel.
  'dai-tdm-tdm-slot-with' must be set to 8.
 
  The PEB2466 codec also supports 28 gpios (signaling pins).

allOf:
  - $ref: /schemas/spi/spi-peripheral-props.yaml
  - $ref: dai-common.yaml#

properties:
  compatible:
    const: infineon,peb2466

  reg:
    description:
      SPI device address.
    maxItems: 1

  clocks:
    items:
      - description: Master clock

  clock-names:
    items:
      - const: mclk

  spi-max-frequency:
    maximum: 8192000

  reset-gpios:
    description:
      GPIO used to reset the device.
    maxItems: 1

  firmware-name:
    maxItems: 1
    description:
      Filters coefficients file to load. If this property is omitted, internal
      filters are disabled.
 
  '#sound-dai-cells':
    const: 0
 
  '#gpio-cells':
    const: 2

  gpio-controller: true

required:
  - compatible
  - reg
  - '#sound-dai-cells'
  - gpio-controller
  - '#gpio-cells'

unevaluatedProperties: false

examples:
  - |
    #include <dt-bindings/gpio/gpio.h>
    spi {
        #address-cells = <1>;
        #size-cells = <0>;
        audio-codec@0 {
            compatible = "infineon,peb2466";
            reg = <0>;
            spi-max-frequency = <8192000>;
            reset-gpios = <&gpio 10 GPIO_ACTIVE_LOW>;
            #sound-dai-cells = <0>;
            gpio-controller;
            #gpio-cells = <2>;
        };
    };