Based on kernel version 6.11
. Page generated on 2024-09-24 08:21 EST
.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 | # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) %YAML 1.2 --- $id: http://devicetree.org/schemas/phy/phy-cadence-torrent.yaml# $schema: http://devicetree.org/meta-schemas/core.yaml# title: Cadence Torrent SD0801 PHY description: This binding describes the Cadence SD0801 PHY (also known as Torrent PHY) hardware included with the Cadence MHDP DisplayPort controller. Torrent PHY also supports multilink multiprotocol combinations including protocols such as PCIe, USB, SGMII, QSGMII etc. maintainers: - Swapnil Jakhade <sjakhade@cadence.com> - Yuti Amonkar <yamonkar@cadence.com> properties: compatible: enum: - cdns,torrent-phy - ti,j7200-serdes-10g - ti,j721e-serdes-10g '#address-cells': const: 1 '#size-cells': const: 0 '#clock-cells': const: 1 clocks: minItems: 1 maxItems: 2 description: PHY input reference clocks - refclk (for PLL0) & pll1_refclk (for PLL1). pll1_refclk is optional and used for multi-protocol configurations requiring separate reference clock for each protocol. Same refclk is used for both PLL0 and PLL1 if no separate pll1_refclk is used. Optional parent clock (phy_en_refclk) to enable a reference clock output feature on some platforms to output either derived or received reference clock. clock-names: minItems: 1 items: - const: refclk - enum: [ pll1_refclk, phy_en_refclk ] reg: minItems: 1 items: - description: Offset of the Torrent PHY configuration registers. - description: Offset of the DPTX PHY configuration registers. reg-names: minItems: 1 items: - const: torrent_phy - const: dptx_phy resets: minItems: 1 items: - description: Torrent PHY reset. - description: Torrent APB reset. This is optional. reset-names: minItems: 1 items: - const: torrent_reset - const: torrent_apb patternProperties: '^phy@[0-3]$': type: object description: Each group of PHY lanes with a single master lane should be represented as a sub-node. properties: reg: description: The master lane number. This is the lowest numbered lane in the lane group. minimum: 0 maximum: 3 resets: minItems: 1 maxItems: 4 description: Contains list of resets, one per lane, to get all the link lanes out of reset. "#phy-cells": const: 0 cdns,phy-type: description: Specifies the type of PHY for which the group of PHY lanes is used. Refer include/dt-bindings/phy/phy.h. Constants from the header should be used. $ref: /schemas/types.yaml#/definitions/uint32 minimum: 1 maximum: 9 cdns,num-lanes: description: Number of lanes. $ref: /schemas/types.yaml#/definitions/uint32 enum: [1, 2, 3, 4] default: 4 cdns,ssc-mode: description: Specifies the Spread Spectrum Clocking mode used. It can be NO_SSC, EXTERNAL_SSC or INTERNAL_SSC. Refer include/dt-bindings/phy/phy-cadence.h for the constants to be used. $ref: /schemas/types.yaml#/definitions/uint32 enum: [0, 1, 2] default: 0 cdns,max-bit-rate: description: Maximum DisplayPort link bit rate to use, in Mbps $ref: /schemas/types.yaml#/definitions/uint32 enum: [2160, 2430, 2700, 3240, 4320, 5400, 8100] default: 8100 required: - reg - resets - "#phy-cells" - cdns,phy-type - cdns,num-lanes additionalProperties: false required: - compatible - "#address-cells" - "#size-cells" - clocks - clock-names - reg - reg-names - resets - reset-names additionalProperties: false examples: - | #include <dt-bindings/phy/phy.h> bus { #address-cells = <2>; #size-cells = <2>; torrent-phy@f0fb500000 { compatible = "cdns,torrent-phy"; reg = <0xf0 0xfb500000 0x0 0x00100000>, <0xf0 0xfb030a00 0x0 0x00000040>; reg-names = "torrent_phy", "dptx_phy"; resets = <&phyrst 0>; reset-names = "torrent_reset"; clocks = <&ref_clk>; clock-names = "refclk"; #address-cells = <1>; #size-cells = <0>; phy@0 { reg = <0>; resets = <&phyrst 1>, <&phyrst 2>, <&phyrst 3>, <&phyrst 4>; #phy-cells = <0>; cdns,phy-type = <PHY_TYPE_DP>; cdns,num-lanes = <4>; cdns,max-bit-rate = <8100>; }; }; }; - | #include <dt-bindings/phy/phy.h> #include <dt-bindings/phy/phy-cadence.h> bus { #address-cells = <2>; #size-cells = <2>; torrent-phy@f0fb500000 { compatible = "cdns,torrent-phy"; reg = <0xf0 0xfb500000 0x0 0x00100000>; reg-names = "torrent_phy"; resets = <&phyrst 0>, <&phyrst 1>; reset-names = "torrent_reset", "torrent_apb"; clocks = <&ref_clk>; clock-names = "refclk"; #address-cells = <1>; #size-cells = <0>; phy@0 { reg = <0>; resets = <&phyrst 2>, <&phyrst 3>; #phy-cells = <0>; cdns,phy-type = <PHY_TYPE_PCIE>; cdns,num-lanes = <2>; cdns,ssc-mode = <CDNS_SERDES_NO_SSC>; }; phy@2 { reg = <2>; resets = <&phyrst 4>; #phy-cells = <0>; cdns,phy-type = <PHY_TYPE_SGMII>; cdns,num-lanes = <1>; cdns,ssc-mode = <CDNS_SERDES_NO_SSC>; }; }; }; ... |