Based on kernel version 6.11. Page generated on 2024-09-24 08:21 EST.
| 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 | .. SPDX-License-Identifier: GPL-2.0-or-later Kernel driver corsair-cpro ========================== Supported devices: * Corsair Commander Pro * Corsair Commander Pro (1000D) Author: Marius Zachmann Description ----------- This driver implements the sysfs interface for the Corsair Commander Pro. The Corsair Commander Pro is a USB device with 6 fan connectors, 4 temperature sensor connectors and 2 Corsair LED connectors. It can read the voltage levels on the SATA power connector. Usage Notes ----------- Since it is a USB device, hotswapping is possible. The device is autodetected. Sysfs entries ------------- ======================= ===================================================================== in0_input Voltage on SATA 12v in1_input Voltage on SATA 5v in2_input Voltage on SATA 3.3v temp[1-4]_input Temperature on connected temperature sensors fan[1-6]_input Connected fan rpm. fan[1-6]_label Shows fan type as detected by the device. fan[1-6]_target Sets fan speed target rpm. When reading, it reports the last value if it was set by the driver. Otherwise returns an error. pwm[1-6] Sets the fan speed. Values from 0-255. Can only be read if pwm was set directly. ======================= ===================================================================== Debugfs entries --------------- ======================= =================== firmware_version Firmware version bootloader_version Bootloader version ======================= =================== |