# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/gpio/st,spear-spics-gpio.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: ST Microelectronics SPEAr SPI CS GPIO Controller

maintainers:
  - Viresh Kumar <vireshk@kernel.org>

description: >
  SPEAr platform provides a provision to control chipselects of ARM PL022 Prime
  Cell spi controller through its system registers, which otherwise remains
  under PL022 control. If chipselect remain under PL022 control then they would
  be released as soon as transfer is over and TxFIFO becomes empty. This is not
  desired by some of the device protocols above spi which expect (multiple)
  transfers without releasing their chipselects.
 
  Chipselects can be controlled by software by turning them as GPIOs. SPEAr
  provides another interface through system registers through which software can
  directly control each PL022 chipselect. Hence, it is natural for SPEAr to
  export the control of this interface as gpio.

properties:
  compatible:
    const: st,spear-spics-gpio

  reg:
    maxItems: 1

  gpio-controller: true
 
  '#gpio-cells':
    const: 2

  st-spics,peripcfg-reg:
    description: Offset of the peripcfg register.
    $ref: /schemas/types.yaml#/definitions/uint32

  st-spics,sw-enable-bit:
    description: Bit offset to enable software chipselect control.
    $ref: /schemas/types.yaml#/definitions/uint32

  st-spics,cs-value-bit:
    description: Bit offset to drive chipselect low or high.
    $ref: /schemas/types.yaml#/definitions/uint32

  st-spics,cs-enable-mask:
    description: Bitmask selecting which chipselects to enable.
    $ref: /schemas/types.yaml#/definitions/uint32

  st-spics,cs-enable-shift:
    description: Bit shift for programming chipselect number.
    $ref: /schemas/types.yaml#/definitions/uint32

required:
  - compatible
  - reg
  - gpio-controller
  - '#gpio-cells'
  - st-spics,peripcfg-reg
  - st-spics,sw-enable-bit
  - st-spics,cs-value-bit
  - st-spics,cs-enable-mask
  - st-spics,cs-enable-shift

additionalProperties: false

examples:
  - |
    gpio@e0700000 {
        compatible = "st,spear-spics-gpio";
        reg = <0xe0700000 0x1000>;
        st-spics,peripcfg-reg = <0x3b0>;
        st-spics,sw-enable-bit = <12>;
        st-spics,cs-value-bit = <11>;
        st-spics,cs-enable-mask = <3>;
        st-spics,cs-enable-shift = <8>;
        gpio-controller;
        #gpio-cells = <2>;
    };