NXP LPC18xx/43xx GPIO controller Device Tree Bindings
-----------------------------------------------------

Required properties:
- compatible		: Should be "nxp,lpc1850-gpio"
- reg			: List of addresses and lengths of the GPIO controller
			  register sets
- reg-names		: Should be "gpio", "gpio-pin-ic", "gpio-group0-ic" and
			  "gpio-gpoup1-ic"
- clocks		: Phandle and clock specifier pair for GPIO controller
- resets		: Phandle and reset specifier pair for GPIO controller
- gpio-controller	: Marks the device node as a GPIO controller
- #gpio-cells 		: Should be two:
			  - The first cell is the GPIO line number
			  - The second cell is used to specify polarity
- interrupt-controller	: Marks the device node as an interrupt controller
- #interrupt-cells	: Should be two:
			  - The first cell is an interrupt number within
			    0..9 range, for GPIO pin interrupts it is equal
			    to 'nxp,gpio-pin-interrupt' property value of
			    GPIO pin configuration, 8 is for GPIO GROUP0
			    interrupt, 9 is for GPIO GROUP1 interrupt
			  - The second cell is used to specify interrupt type

Optional properties:
- gpio-ranges		: Mapping between GPIO and pinctrl

Example:
#define LPC_GPIO(port, pin)	(port * 32 + pin)
#define LPC_PIN(port, pin)	(0x##port * 32 + pin)

gpio: gpio@400f4000 {
	compatible = "nxp,lpc1850-gpio";
	reg = <0x400f4000 0x4000>, <0x40087000 0x1000>,
	      <0x40088000 0x1000>, <0x40089000 0x1000>;
	reg-names = "gpio", "gpio-pin-ic",
		    "gpio-group0-ic", "gpio-gpoup1-ic";
	clocks = <&ccu1 CLK_CPU_GPIO>;
	resets = <&rgu 28>;
	gpio-controller;
	#gpio-cells = <2>;
	interrupt-controller;
	#interrupt-cells = <2>;
	gpio-ranges =	<&pinctrl LPC_GPIO(0,0)  LPC_PIN(0,0)  2>,
			...
			<&pinctrl LPC_GPIO(7,19) LPC_PIN(f,5)  7>;
};

gpio_joystick {
	compatible = "gpio-keys";
	...

	button0 {
		...
		interrupt-parent = <&gpio>;
		interrupts = <1 IRQ_TYPE_EDGE_BOTH>;
		gpios = <&gpio LPC_GPIO(4,8) GPIO_ACTIVE_LOW>;
	};
};