# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/display/panel/truly,nt35597-2K-display.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: Truly NT35597 DSI 2K display

maintainers:
  - Neil Armstrong <neil.armstrong@linaro.org>

description: |
  Truly NT35597 DSI 2K display is used on the Qualcomm SDM845 MTP board.

allOf:
  - $ref: panel-common-dual.yaml#

properties:
  compatible:
    const: truly,nt35597-2K-display

  reg:
    maxItems: 1

  vdda-supply:
    description: regulator that provides the supply voltage Power IC supply

  vdispp-supply:
    description: regulator that provides the supply voltage for positive LCD bias

  vdispn-supply:
    description: regulator that provides the supply voltage for negative LCD bias

  reset-gpios: true

  mode-gpios:
    description:
      Gpio for choosing the mode of the display for single DSI or Dual DSI.
      This should be low for dual DSI and high for single DSI mode.

  ports:
    required:
      - port@0
      - port@1

required:
  - compatible
  - reg
  - vdda-supply
  - reset-gpios
  - mode-gpios
  - ports

additionalProperties: false

examples:
  - |
    #include <dt-bindings/gpio/gpio.h>
 
    dsi {
        #address-cells = <1>;
        #size-cells = <0>;
 
        panel@0 {
            compatible = "truly,nt35597-2K-display";
            reg = <0>;
 
            vdda-supply = <&pm8998_l14>;
            vdispp-supply = <&lab_regulator>;
            vdispn-supply = <&ibb_regulator>;
 
            reset-gpios = <&tlmm 6 GPIO_ACTIVE_LOW>;
            mode-gpios = <&tlmm 52 GPIO_ACTIVE_HIGH>;
 
            ports {
                #address-cells = <1>;
                #size-cells = <0>;
 
                port@0 {
                    reg = <0>;
 
                    panel0_in: endpoint {
                        remote-endpoint = <&dsi0_out>;
                    };
                };
 
                port@1 {
                    reg = <1>;
 
                    panel1_in: endpoint {
                        remote-endpoint = <&dsi1_out>;
                    };
                };
            };
        };
    };
...