About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog

Documentation / i2c / busses / scx200_acb


Based on kernel version 4.16.1. Page generated on 2018-04-09 11:53 EST.

1	Kernel driver scx200_acb
2	
3	Author: Christer Weinigel <wingel@nano-system.com>
4	
5	The driver supersedes the older, never merged driver named i2c-nscacb.
6	
7	Module Parameters
8	-----------------
9	
10	* base: up to 4 ints
11	  Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices
12	
13	  By default the driver uses two base addresses 0x820 and 0x840.
14	  If you want only one base address, specify the second as 0 so as to
15	  override this default.
16	
17	Description
18	-----------
19	
20	Enable the use of the ACCESS.bus controller on the Geode SCx200 and
21	SC1100 processors and the CS5535 and CS5536 Geode companion devices.
22	
23	Device-specific notes
24	---------------------
25	
26	The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820.
27	If the scx200_acb driver is built into the kernel, add the following
28	parameter to your boot command line:
29	  scx200_acb.base=0x810,0x820
30	If the scx200_acb driver is built as a module, add the following line to
31	a configuration file in /etc/modprobe.d/ instead:
32	  options scx200_acb base=0x810,0x820
Hide Line Numbers


About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog